Polk Audio Pa D4000.4 Pad Series 4-Channel Amplifier - 400w
Condition: New
Free Ground Shipping*
Polk Audio Pa D4000.4 Pad Series 4-Channel Amplifier - 400w
PA D4000.4 PAD Series 4-Channel Amplifier - 400W
When install space is at a premium, but your sound system demands plenty of power to realize its full potential, Polk Audio’s new super-efficient D Series amplifiers are a very cool solution.
Polk's PA D4000.4 4-channel amplifier may be small, but it can power your front and rear speakers with up to 125 watts RMS each. Or, you can switch this little beast over to 2-channel mode to drive a couple subwoofers with up to 200 watts RMS each. However you use it, this amplifier will fit in almost any location.
Separate high- and low-pass filters on the front and rear channels allow this versatile amp to run a variety of speaker systems, like bi-amped mid-bass and tweeter components, or two front speakers and a sub.
Features:
- Super-Efficient Class D Bridgeable Design - Runs cooler than conventional amps.
- High-Speed MOSFET Switching power supply.
- Front and rear level controls.
- Protection - thermal, DC offset, reverse polarity and short circuit.
- Nickel-plated wire terminals and RCA connectors.
- Stainless steel hardware.
Technical Specifications:
- Number of Channels - 4
- Frequency Response - 20Hz - 20KHz
- 2 Ohm RMS Power (14.4V) Per Channel - 4 x 200W
- 4 Ohm RMS Power (14.4V) Per Channel - 4 x 125W
- 4 Ohm RMS Power Bridge (14.4V) Channel - 2 x 400W
- Signal-to-Noise Ratio - >105dB
- Product Dimensions (with panels) (H x W x D) -1.81'' x 10.94'' x 6.75''
*Sold as an Individual
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
Manufacturer Part Number: PAD4000.4
| Special Shipping Message | Free Ground Shipping* |
|---|---|
| Manufacturer Part Number: | PAD4000-4 |
| Specifications: |
|
Return Policy
Hodges Marine accepts returns for up to thirty (30) days after shipment. Our return policy does not apply to the following goods: Open software, mapping/chart data cards, international orders, freight truck only items, and special order items. These items are not eligible for return, refund or exchange. Shipping charges (if any) are non-refundable. If your return is accepted by Us, We will provide one of the following within a reasonable time: an exchange of merchandise for the item returned, a non-transferable merchandise credit, a credit to the payment card or original method of payment used to pay for the item, a check, or another remedy that we determine in good faith is appropriate in the circumstances. Customer must request a return merchandise authorization (RMA) through the product returns link on our website or by emailing us at [email protected]. A RMA number will be issued with instructions for returning the package within a reasonable time (normally 1-3 business days).
Login and Registration Form